Unitec Wash Select II POS Installation Manual - Manual (Page 15)

W A S H S E L E C T I I
Document Number: WS21001 9
Document Title: Wash Select II POS Installation Manual
3 Mechanical Installation
Note:
Unitec recommends the bricking in of the WSII when installed on property that is not
manned or is not in plain sight of station or business personnel.
Unitec also recommends the connection of the WSII to a monitored security system in
these situations or any situation where vandalism or theft may occur.
The use of the included door sensor and a customer supplied shock sensor mounted
on the door is recommended as well.
3.1 Bricking in the Wash Select II
For optimum security the Wash Select II unit should be mounted on a concrete slab and
bricked in.
Tips on Bricking in:
Conduit openings are at the right side of the bottom of the case.
Bolt holes are at the bottom of the case to secure to the concrete slab.
The concrete slab should be built so that the bottom of the Wash Select II ™ case is
32.5” from the floor.
Outer dimensions of the Wash Select II are:
Including reinforcing
band along front
edge
Not including reinforcing
band around front edge
Tall 23.62” 23.24”
Wide 18.11” 17.74”
Deep 19.26” 19.25”
The following drawing shows such an installation: