Unitec Wash Select II POS Installation Manual - Manual (Page 26)

W A S H S E L E C T I I
Document Number: WS21001 20
hopper handle, and pulling it out the front. The cable that connects it to the CPU board will
need to be removed as well. Once the power connector has been located, proceed with the
rest of this section.
4.6.1 Measure Wire Lengths
1. Along with the wires that were already pulled there should be a three-conductor
cable for the main 120 VAC power. This cable should be 16 AWG or greater, and
should consist of an environmentally rated black, white, and green colored wire.
When this wire is located, use the same method employed to install the modem
to neatly route this wire back to the Wash Select II power supply.
2. Use the wire strippers to peel back about 2”-3” inches of insulation from the main
cable, and then remove approximately ¼” inch from the ends of the individual
wires.
4.6.2 Attach the Three-prong Connector
1. Locate the 3-pronged AC connector (See Figure 8). Disassemble the outer
housing by loosening the housing assembly screw, located on the top of the AC
connector.
Figure 11. AC Connector
Once opened, you will see the white plastic stabilizer plate as well as the black line insulator.
(See Figure 9)
Document Title: Wash Select II POS Installation Manual