tekmar 369 Zone Control Installation - Manual (Page 21)

Copyright © D 369 -10/00 21 of 32
0 to 9999 hr
0 to 9999 hr
0 - 255
0 - 255
The total number of Zn 5 relay running hours since this item
was last cleared.
The total number of Zn 6 relay running hours since this item
was last cleared.
The number of times that the microprocessor in the control
has reset since this item was last cleared. The control will
reset itself if it has experienced some form of interference that
has disrupted its operation. This can be used to give an
indication of the quality of the electrical environment that the
control has been installed in.
The number of times that the control has been powered up
since this item was last cleared. This number will increase if
there is a lowering of the input voltage beyond the control’s
usable range. This item can also be used as an indication of
the quality of the power source.
LT
D
INST ADV
Range
Access
Level
Description Item Field
USER
Note: To clear the recorded information in the specific item field, press and hold ▲ and ▼.
369 Monitor Menu (2 of 2)
369 Time Menu (1 of 1)
:00 to :59
Default = :00
Section LT
D
INST ADV
Range
Access
Level
Description Item Field
USER
SATURDAY, . . . ,
FRIDAY
Default = SATURDAY
12: AM to 11: PM or
00: to 23:
Default = 12: AM
12 hr, 24 hr
Default = 12 hr
Real time clock minutes.
DIP switch = Setback
Real time clock hours.
DIP switch = Setback
Day of the week.
DIP switch = Setback
Method of displaying time on the control’s display.
DIP switch = Setback
C
C
C
C
AM
Displays current time of day and the day of week.
DIP switch = Setback
C
AM
- 01/09
- 01/09