tekmar 032 Timer User Manual
Data brochure, D 032, Timer 032
- Data Brochure
Timer 032
D 032
12/08
1
of
4
©
2008
D 032 - 12/08
Installation
STEP ONE
———————
GETTING READY
Check the contents of this package. If any of the contents are missing or damaged, please contact your wholesaler or tekmar sales
representative for assistance.
Type 032 Includes: One Timer 032, Data Brochure D 032
STEP TWO
———————
REMOVING THE FRONT COVER
Place a screwdriver or similar object into the small slot located in the top of
the timer. Push the screwdriver against the plastic tab and pull the top of the
front cover so that it pivots around the bottom edge of the base.
STEP THREE
——————
MOUNTING THE BASE
Mount the base directly to the wall using two #6 1” screws. The screws are
inserted through the mounting holes and must be securely fastened to the
wall. If possible, at least one of the screws should enter a wall stud or similar
surface. If the timer is to be mounted to a 2” x 4” electrical box, order an Adap-
tor Plate 007. This plate mounts to the electrical box and the timer mounts to
the plate.
Menu
Item
Remove cover
Push tab
1
2
#6 1" screws
The tekmar Timer 032 is a microprocessor-based timer which can be programmed to provide up to
two occupied and two unoccupied events each day. The timer can be programmed for either a 24 hour
schedule or a 7 day schedule. The internal SPST relay operates based on the schedule programmed by
the user. The user can override any programmed schedule either temporarily or permanently.
In the event of a power loss, the programmed schedule information is permanently retained in memory.
The clock continues to operate for up to four hours using a batteryless backup.
Sequence of Operation
The timer has an internal relay that switches on and off according to the schedule programmed
by the user and the DIP switch located in the back of the timer.
If the DIP switch is set to Relay NO (normally open), the contact is open during an occupied
event and is closed during an unoccupied event. If the timer is to be used in conjunction with
a tekmar reset control, the DIP switch must be set to the Relay NO setting.
If the DIP switch is set to Relay NC (normally closed), the contact is closed during an
occupied event and is open during an unoccupied event.
DIP Switch
R
ela
y NC / R
e
la
y NO
Po
w
e
r:
24
V
±
10
%
60
R
ela
y:
24 V
(ac
) 2 A