SoundOff Signal Apex LED - Manual (Page 7)

FIXED HEIGHT BRACKETS PERMANENT
MOUNTING
1. Locate the permanent hardware kit that is included. Kit will include (4) 6mm x 16mm hex head bolts, (4) lock washers, (4) hex
nuts.
2. Attach fixed height brackets to lightbar using M6 Hex bolts, nuts and lock washers. Brackets should be adjusted to identical
positions at both ends of lightbar. See Figure 1.
3. Position the lightbar on the vehicle roof in the desired mounting location. The recommended location is directly above the B-
Pillars. This is the strongest part of the roof. Make sure that the bar is centered on the vehicle left to right. Adjust bracket
location on lightbar base.
4. Mark the location for the (2) holes that need to be drilled through the roof that will attach the fixed height brackets to the roof.
5. Determine the best location for cable entry depending on the configuration of your bar. Using a 1-1/4” hole saw, drill hole in the
marked location. Be mindful that you do not drill through any roof support members or the interior headliner.
6. Using a drill bit, drill the 2 holes in the locations that you marked in step 4 based on customer supplied mounting hardware.
Clean and debur each hole.
7. Attach the lightbar to the vehicle using customer supplied hardware. Use (1) flat washer and locking nut for each bolt. You
should have a total of 2 bolts attaching the lightbar to the roof of the vehicle. See Figure 2 for details. It is recommended that
you add silicone around the hole to ensure roof sealing.
8. Route cables into vehicle. Use supplied rubber grommet in roof for the sealing/protection of wires. It is recommended that
silicone be placed around the grommet to ensure roof sealing.
WARNING - ROUTE WIRES ONLY IN LOCATIONS THAT ARE NOT SUBJECTED TO POTENTIAL WEAR. MAKE SURE TO
AVOID ROUTING WIRES IN THE DEPLOYMENT AREA OF YOUR AIR BAG. REFER TO YOUR VEHICLE’S OWNER’S
MANUAL FOR AIR BAG DEPLOYMENT ZONES.
FIGURE 1
Roof Cut-away
2x 1/4”-20 x 1”
Hex Head Screw 2x 1/4” Lock
Washers
2x 1/4” Flat
Washers
2x 1/4” -20
Square Nuts
FIGURE 2
Page 7
9. Route cable down through the “B” pillar and towards switch panel. Refer to the instructions included with your switch for
switch wiring information.
Slots for
adjustablitlity
for correct roof fit