Sindoh M612 - Manual (Page 19)

3
Before Using the Machine
3. Safety Information
Plug the power cord into a properly grounded outlet which is near and quickly accessible from the machine.
Do not use or place the machine in wet or humid environment.
Caution Injuries
- The machine uses laser technologies. Use of controls, adjustments, or execution of procedures
other than those specified in this manual can result in hazardous radiation exposure.
The product uses a method heating the printing media so that gas may be emitted from paper due
to heating. In order to prevent the emission of harmful gas, the section addressing the details on the
printing media in the operating instructions should be understood.
Caution Heated Surfaces
- The inside of the machine may be hot. Do not touch any hot part before it is cooled down to avoid
from any injury owing to the heated part.
Caution Injuries
- To prevent from any personal injuries or machine damages you need to follow the below instructions
before moving the machine. Turning the power switch off and then unplug the power cords from the
power outlet. Unplug and release all the cords and cables before moving the machine.
Do not lift the optional feeder and the MFP machine together at the same time. Lift only the
machine first, and then the feeder by using grips available at both sides. Always use only the power
cords provided with this machine or the one approved by the manufacturer.
Caution Electrical Shock
- Proceed your work after turning off the machine and unplugging the power cord from the outlet in
case of accessing the system board, or installing hardware or optional memory devices after having
already installed MFP machine. If the machine is connected with any other device, turn it off and
separate the cables from the machine.
Caution Electrical Shock
- This product has been designed, tested and approved to meet strict safety requirements
of international safety standard. Some safety features of parts may not clearly work. The
corresponding manufacturer of the machine shall not be responsible for usage of any other
replacement parts.