Banner SureCross DX80 Wireless Networks - Manual (Page 51)

51
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross Wireless Network
Product Manual
System Layouts
Serial data radios are used to connect a control system (e.g. a Modbus RTU master) to one or more local wireless networks through a DX80
Gateway operating as a Modbus slave. The data radios are transparent; they do not need addressing, error checking, or acknowledgement in
the radio packets. Instead, a data stream appearing on the serial input of one radio is reproduced on the serial outputs of all other radios within
the same network.
Item Model No. Description
1
DX80G... Gateway
2
DX80DR*M-H MultiHop data radio, 900MHz or 2.4GHz
3
DX80N... FlexPower Nodes or Nodes
* For RS-232 communications, an RS-232 crossover cable must be used to connect the data radio to the Gateway.
Host System
(Modbus Master)
Fieldbus Connection
Data Radio
2
Fieldbus Connection
Data Radio
Gateway
1
3
Fieldbus Connection
Data Radio
Gateway
1
3
2 2
DX85 as Modbus
Slave