Banner SureCross DX80 Wireless Networks - Manual (Page 39)

39
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross Wireless Network
Product Manual
Advanced Setup
Continuing from the previous menu position, follow these steps to set the parity.
1. Press button 1 once to move to the next field, the PARITY field.
2. Press button 2 once to enter the PARITY submenu and to display the current setting. Single-click Gateway push button 1 to cycle
through the available options. Stop on the desired setting.
The options are NONE, EVEN, ODD. The factory default is NONE.
3. Press button 2 once to save the new setting.
To finish
1. If using a network ID (NID), adjust both rotary switches back to the NID value.
To avoid losing the network connection between the Gateway and Nodes, reset the rotary switches back to their appropriate values
before leaving the *DVCFG sub-menus. If the Gateway and Nodes lose their connection, the network may take up to 20 seconds to
re-synchronize.
2. Double-click Gateway push button 2 to return to the Device Configuration (*DVCFG) menu.
3. Click Gateway push button 1 until reaching the *RUN menu option.