DJI Phantom 2 Vision Plus User Manual - Manual (Page 46)

PC / MAC Assistant
46 © 2014 DJI. All Rights Reserved.
DMG installer supports Mac OS X 10.9 or above.
Phantom 2 Vision+ Assistant on Mac OS X and Windows are the same. Assistant pages shown in this manual
are from the Windows version.
2 Using Assistant
The Phantom 2 Vision+ Assistant is used to configure the flight control system and upgrade firmware. The Phantom RC
Assistant is used to configure the Remote Control and upgrade its firmware.
2.1 Using the Phantom 2 Vision+ Assistant
Figure 111
(1) Power on the PC and the Phantom 2 Vision+. Connect the Phantom 2 Vision+ to the PC with a Micro-USB cable. DO
NOT disconnect until configuration is finished.
(2) Run Phantom 2 Vision+ Assistant and wait for the Phantom 2 Vision+ to connect. Watch the indicators on the
bottom of the screen. When connected successfully, the Computer Connection status is and Data Exchange
Indicator blinks .
(3) Choose [Basic] or [Advanced] configuration pages.
(4) View and check the current configuration in the [View] page.
View configurations
RC, Gain
Gimbal, Battery, Flight Limits
Data Exchange Indicator
Computer Connection status
Function switch between Phantom
and Naza-M working modo
Language swap
Account, software version
Firmware upgrade
IMU calibration
* This image is for reference
only. Please refer to the
actual user interface.
Figure 112
Do not enable Naza-M mode before finishing “Advanced Flight Maneuvers” in the "Phantom Pilot Training
Guide”.
Enable Phantom mode by tapping the same button if Naza-M mode is enabled. Once changed to Phantom
working mode, all parameters will return to factory settings.
2.2 Firmware Upgrade of the Phantom 2 Vision+
(1) Click [Upgrade] icon to check the current firmware version and whether the installed firmware is the latest version. If
not, click links to upgrade.
(2) Wait until the Assistant shows “finished”. Click OK and power cycle the Phantom 2 Vision+ after 5 seconds. Once
complete, firmware is up to date.
Using Assistant