DJI Phantom 2 Vision Plus User Manual User Manual
Page 44
DJI VISION App Usage
44
©
2014 DJI. All Rights Reserved.
A circle on the map, as shown in Figure 104, indicates a restricted, No Waypoint area. Waypoints cannot be
To achieve the optimal video transmission quality, the aircraft is set to operate within a 500m-radius area from Home point.
Tap on a waypoint to open a waypoint properties window. Slide the white dot right to adjust waypoint altitude. The
default altitude is set to 98 feet (30 m) and can be adjusted from 0 to 650 feet (200 m). Tap “OK” to save waypoint
settings. To delete current waypoint, tap . Modify longitude and latitude value using the input box.
Figure 105
Step 3 Preview a Mission:
Tap “Done” to preview the mission when all waypoints are set. A prompt similar to the one below will appear.
This prompt lists all waypoints and their altitudes. The aircraft will fly to each waypoint listed. If there is a difference in altitude
between waypoints, the aircraft will adjust its altitude as it flies between points. When ready, tap “GO” to begin mission.
Figure 106
Figure 107
Aircraft reacts differently to the “GO” command:
If aircraft is on the ground, the aircraft takes off automatically and ascend 16 feet (5m) then fly to the first waypoint.
If aircraft is in the air, the aircraft flies to the first waypoint.
Step 4 Executing Flight Mission
The aircraft flies to each waypoint in numerical order. As it flies, swipe back into the DJI Vision app camera GUI to
control camera tilt and capture photos or video. Tap to pause the mission during the flight, and aircraft will then start
hovering. Tap to resume mission. If you wish to regain control of the aircraft, toggle the S1 switch on remote control
from (Position-1) to either (Position-2) or (Position-3) to discontinue the current mission.
Step 5 Landing
When all waypoints have been visited, the aircraft will return to its Home point and hover. Regain control of the aircraft
and land it manually. You may also tap button to initiate “Go Home” procedure. Aircraft will abort current mission,
return to Home point and auto land.
113.94984
22.54074
waypoint1
Longitude
Height
Latitude