beautypg.com

2 video suggestions and tips, 4 failsafe function, 1 when will failsafe activate – DJI Phantom 2 Vision Plus User Manual User Manual

Page 27: 2 failsafe procedure

background image

Flight

©

2014 DJI. All Rights Reserved.

27

When the Rear LED Flight Indicator blinks yellow rapidly during flight, the aircraft has entered Failsafe mode.

Refer to Failsafe Function(Page 27) for details.

A low battery level warning is indicated by the Rear LED Flight Indicator blinking red slowly or rapidly during

flight. Refer to the Low Battery Level Warning Function(Page 28) for details.

View tutorials about flight for more flight information:www.dji.com/phantom2visionplus/training.

Aircraft and battery performance is subject to environmental factors such as air density and temperature. Be

very careful when flying 3000 meters (9800 feet) or more above sea level, as battery and aircraft performance

may be reduced.

3.2 Video Suggestions and Tips

(1) Work through the check list before each flight.

(2) Set the gimbal working mode to Stabilized.

(3) Aim to shoot when flying in Ready to Fly only.

(4) Always fly in good weather, such as sunny or windless days.

(5) Change camera settings to suit you. These include FOV, photo format and exposure compensation.

(6) Take flight tests to establish flight routes and scenes.

(7) Push the sticks gently to make aircraft movements stable and smooth.

4 Failsafe Function

The Phantom will enter Failsafe mode when its connection to the Remote Control is lost. The Flight Control System will

automatically control the aircraft to return to home and land to prevent injury or damage.

Home Point: When the Phantom enters ‘Ready to Fly’ from the ‘Ready to Fly status (non-GPS)’, the GPS

coordinates will be recorded and set as the home point.

When Remote Control signal is lost, the aircraft will return to the recorded home point coordinates and land.

Home point coordinates are used to calculate the horizontal distance of the aircraft (shown as “Distance” on the

GUI of the DJI VISION App).

After successfully record the home point, rear LED flight indicators blink fast green.

Dynamic Home Point: The Home point will be reset to position of the mobile device at specific time intervals.

Enable dynamic home point in DJI Vision app or Phantom 2 Assistant.

Dynamic home point is only available to the GPS-enabled mobile device. Turn on GPS and data service to

obtain higher accuracy of the mobile device position.

Dynamic home point is useful in situations when you are in motion and require a Home point that is different

from the takeoff point.

4.1 When Will Failsafe Activate?

(1) The Remote Control is powered off.

(2) The Phantom has flown out of effective remote control range.

(3) The signal between the Remote Control and the Phantom has been blocked.

(4) There is interference causing a signal problem with the Remote Control.

4.2 Failsafe Procedure

Initiating the Failsafe mode from different flying statuses will results in different landing processes.

Ready to Fly(non-GPS)- Automatic landing

The Flight Control System will keep the aircraft level during descent and landing. It may be drift during the descent and landing process.

Ready to Fly- Automatic go home and land

The Flight Control System will automatically control the aircraft to fly back to the home point and land.

Failsafe Function

5 Fly back to home point

LED Flight Indicator Yellow flashing

4 Signal lost lasts 3s, begin to go home

LED Flight Indicator Yellow flashing

2 Flying

LED Flight Indicator Green flashing

3 Remote Control signal lost

LED Flight Indicator Yellow flashing

6 Landing after hovering 15s

LED Flight Indicator Yellow flashing

Figure 52

Height over home point>20m

Elevate to 20m

Height over home point<=20m

20m

1 Record Home Point

LED Flight Indicator

Yellow flashing Green flashing