DJI Phantom 2 Vision Plus User Manual - Manual (Page 26)

Flight
26 © 2014 DJI. All Rights Reserved.
If compass calibration is needed before flight, a prompt will appear on the DJI VISON App’s camera page. It will
disappear after successful calibration.
1.2 When to Recalibrate
(1) When compass data is abnormal, the rear LED flight indicator will blink red and yellow.
(2) Flying in different location to last flight.
(3) Mechanical structure of the Phantom has changed, i.e. changed mounting position of the compass.
(4) Severe drifting occurs in flight, i.e. Phantom does not fly in straight lines.
2 Starting/Stopping the Motors
2.1 Starting Motors
A Combination Stick Command (CSC) is used to start the motors instead of
simply pushing the stick up. Push both sticks to their bottom corners to start the
motors. Once the motors have spun up, release both sticks simultaneously.
2.2 Stopping Motors
There are two methods to stop the motors.
Method 1: When the Phantom has landed, push the throttle down, then conduct CSC. Motors will stop immediately.
Release both sticks once motors stop.
Method 2: When the aircraft has landed, push the throttle down and hold. Motors will stop after 3 seconds.
Figure 49
Figure 50 Figure 51
[1] [2]
Do not execute CSC during normal flight. This will stop the motors and cause the aircraft to drop without control.
Conduct the CSC as neatly as you can. Release the sticks once motors start/stop.
Pull down the throttle stick to descend. The stick will lock into place and the aircraft will descend steadily. Push
the throttle stick upward to release throttle lock.
3 Flight Test
3.1Take off/Landing Procedures
(1) Place the Phantom 2 Vision+ on open flat ground with battery indicators facing towards you.
(2) Power on the Remote Control and Range Extender, then the Smart Flight Battery.
(3) Launch the DJI VISION App and start bind it with your smartphone then enter the camera preview page.
(4) Wait until the Rear LED Flight Indicator blinks green. This means it has initialized and is Ready to Fly. If it flashes yellow,
it is in Ready to Fly (non-GPS) mode and will require more careful flight. Execute the CSC command to start motors.
(5) Push the throttle up slowly to take off. Refer to Remote Control Operation (Page 18) for more details.
(6) Shoot photos and videos using the DJI VISION App. Refer to DJI VISION App Usage (Page 32) for more details.
(7) To land, hover over a level surface and gently pull down on the throttle gently to descend.
(8) After landing, execute the CSC command or hold the throttle at its lowest position for 3 seconds or more until the
motors stop.
(9) Turn off the smart battery, Range Extender and Remote Control.
Starting/Stopping the Motors / Flight Test