Brandmotion 1013-9550 - Manual (Page 11)

INSTALLATION
INSTRUCTIONS
9550 Instructions 1-8-13.doc Page 11 of 13
59. Remove the D-pillar panel and unhook the speaker
wire by pulling the connectors apart with your
fingers. (Figure 52)
Figure 52
60. Remove the pushpin in the left side edge of the
headliner. (Figure 53)
Figure 53
61. Pull trailing edge of headliner down to route Chassis
Harness under leading edge of headliner and
towards the driver’s side D-pillar. (Figure 54)
Figure 54
62. Remove both ends of the electrical bridge between
the liftgate and rear of the vehicle. Route the front
connector (identifiable by the presence of a green
lock tab) of the supplied Chassis Harness through
the bridge (Figure 55).
Figure 55
63. Route the supplied Chassis Harness down the D-
Pillar behind the trim.
64. Remove the driver’s side third row seat.
65. Starting from the middle of the driver’s side rear
quarter trim panel, use a plastic trim tool to tuck the
supplied Chassis Harness under the trim panel. Work
towards the rear, then towards the front. (Figures
56 & 57)
Figure 56
Figure 57