Brother DCP-6690CW - Manual (Page 50)

Chapter 5
44
f
After you have chosen all the photos, do
one of the following:
Press OK and change the print
settings. Press Print Setting.
(See page 48.)
If you do not want to change any
settings, press OK and then
Color Start to print.
Enhance Photos
5
You can edit and add effects to your photos
and view them on the LCD before printing.
Note
The Enhance Photos feature is supported
by technology from Reallusion, Inc.
a
Make sure you have put a memory card
or USB Flash memory drive in the
correct slot.
Press (Photo Capture).
b
Press Enhance Photos.
Note
• Press d or c to scroll through all photos.
You can forward and rewind the
thumbnails by holding these keys. The
photo is not shown during this operation.
• Press to start Slide Show.
c
Press and choose a photo from the
thumbnails.
d
Press and choose Enhance or Trim.
You can also choose both together.
Press OK.
e
Do one of the following:
If you chose Enhance, go to step f.
If you chose Trim, go to step g.
f
Press and choose the effect you wish to
add.
Press OK.
Do one of the following:
If you choose Trim in step d, go to
step g.
If you do not choose Trim in step d,
go to step h.
Note
• You have 7 ways to add effects to your photo.
(Auto Correct)
The machine decides the suitable
effect for your photo.
(Enhance Skin)
Best used for adjusting portrait
photographs. It adjusts human skin
color. Press d or c to adjust the level of
contrast.
(Enhance Scenery)
Best used for adjusting landscape
photographs. It highlights green and
blue areas in your photo. Press d or c
to adjust the level of contrast.
(Remove Red-Eye)
The machine will attempt to remove
red-eye from your photo. If red-eye
detection fails, you can press the
Try Again
button to re-detect.
(Monochrome)
You can convert the color of your
photo to monochrome.
(Sepia)
Adds a sepia tone (shades of brown)
effect to your photo.
(Auto Correct
Remove Red-Eye
)
The machine decides the suitable
effects for your photo. Also, it will
attempt to remove red-eye from your
photo.