Bird Technologies 3129 Display - Manual (Page 49)

33
Admin Screen
The Admin screen has four tabs, Network, Email Alerts, SNMP, and Passwords.
After making changes in one or all of the tabs, click the Apply All Changes button
to record your settings in memory.
For more information about the Admin screen, refer to the help in the software
(click on the Help button).
Network Tab
In the Networking tab (Figure 19 on page 33), you can specify the following infor-
mation about the address of the BPM-E: IP address, subnet mask, gateway IP,
DHCP host name, and whether or not DHCP is used.
If you use the ethernet connection to communicate with the BPM-E, you need to
specify a unique IP address. An IP address is required even if you connect the
BPM-E directly to a computer that is not on a network. Contact your IT profes-
sional for assistance in determining the IP address, subnet mask, and information
about DHCP use and name.
Figure 19 WebTool Admin Screen, Network Setup
Email Alerts Tab
In the Email Alerts tab (Figure 20 on page 34), you can specify the following infor-
mation: the SMTP server IP, the SMTP port, whether or not to use the email alerts,
the email address of the BPM-E, and the email addresses of two people to notify
when an alarm occurs (optional).
You can have the WebTool software contact two specified recipients via email if
an alarm occurs. The BPM-E needs to be connected to a computer or server that
has email capabilities. Contact your IT professional for assistance in determining
the SMTP server IP and port. The text you enter at the left of the @ symbol in
the From email address will uniquely identify this BPM-E in all sent emails. Use
text that will identify the BPM-E and its location. The text at the right of the @
symbol is the email domain information for your server.