Bird Technologies 3129 Display - Manual (Page 45)

29
Main Screen
The Main screen is the default screen you see when you open the WebTool soft-
ware (Figure 14, page 29). The Main screen identifies the BPM-E at the top of
the window. The center of the screen displays measurement data that is being
received from the BPM-E. You can set the refresh rate from 1 second to 60 sec-
onds (how frequently the software updates the data from the BPM-E). At the
bottom of the window, the status bar displays various information about the
software and uses three alert colors, red - a fatal error (cannot establish connec-
tion, connection lost), yellow - a warning (cannot complete a user request, user
does not have access permission), gray - normal operation.
For more information about the Main screen features, refer to the help section
in the software (click on the Help button).
The alarm condition area (Figure 15, page 30) will display three conditions
•
No alarm (green text) - no alarm condition exists
•
Latched (red text) - an alarm condition did occur but its cause has been
fixed or the cause no longer exists.
•
Alarm (red text) - an alarm condition that has occurred and has not
gone away or been reset is identified by text (VSWR, High Pwr, Low Pwr,
or any combination of these if more than one alarm exists).
You can reset the alarm at the BPM-E by pressing the reset button or by clicking
on the Reset Alarm button on the Web Tool Main screen. If the cause of the
alarm is still present, the message cannot be reset.
Figure 14 BPM-E WebTool Software, Main Screen