Rockwell Automation 1606-XLP XM Electronic Overspeed Detection System - Manual (Page 24)

Publication GMSI10-UM015B-EN-E - June 2011
24 Installing the XM Electronic Overspeed Detection System
Connecting Wiring for Your
XM EODS Wiring to the module is made through the terminal base unit on which the
module mounts. The XM-220 is compatible only with the XM-941 terminal
base unit, Cat. No. 1440-TB-B. The XM-442 is compatible only with the
XM-946 terminal base unit, Cat. No. 1440-TB-G.
Figure 2.6 XM Terminal Base Unit
Terminal Block Assignments
The terminal block assignments and descriptions for the XM-220 and XM-442
modules are shown below:
ATTENTION
The terminal block assignments are different for different
XM modules. The following tables apply only to the
XM-442 and XM-220 modules. Refer to the installation
instructions for the specific XM module for its terminal
assignments.
WARNING
EXPLOSION HAZARD
Do not disconnect equipment unless power has been
removed or the area is known to be nonhazardous.
Do not disconnect connections to this equipment unless
power has been removed or the area is known to be
nonhazardous. Secure any external connections that mate
to this equipment by using screws, sliding latches, threaded
connectors, or other means provided with this product.
XM-941 (Cat. No. 1440-TB-B) and XM-946
(Cat. No. 1440-TB-G)