Document conventions – Rockwell Automation 1606-XLP XM Electronic Overspeed Detection System User Manual
Page 11
Publication GMSI10-UM015B-EN-E - June 2011
Introduction 11
Chapter 2 "Installing the XM Electronic Overspeed Detection System"
describes how to install, wire, and operate the XM EODS.
Chapter 3 "Configuring the XM EODS" provides information to help you
configure your XM Electronic Overspeed Detection System using the XM
Serial Configuration Utility software.
Appendix A "Specification" lists the technical specifications for the XM-442
Voted EODS Relay module.
For definitions of terms used in this Guide, see the Glossary at the end of the
Guide.
Document Conventions
There are several document conventions used in this manual, including the
following:
The XM Electronic Overspeed Detection System is also referred to as XM
EODS and electronic overspeed detection system throughout this manual.
TIP
A tip indicates additional information which may be
helpful.
EXAMPLE
This convention presents an example.