Rockwell Automation 1440-TPR06-00RE XM-360 Process Module - Manual (Page 11)

Publication GMSI10-UM006C-EN-P - August 2010
Introduction 3
Organization
To help you navigate through this manual, it is organized in chapters based on
these tasks and topics.
Chapter 1 “Introduction” contains an overview of this manual and the
XM-360 module.
Chapter 2 “Installing the XM-360 Process Module” describes how to install,
wire, and use the XM-360 module.
Chapter 3 “Configuration Parameters” provides a complete listing and
description of the XM-360 parameters. The parameters can be viewed and
edited using the XM Serial Configuration Utility software and a personal
computer.
Appendix A “Specifications” lists the technical specifications for the XM-360
module.
Appendix B “DeviceNet Information” provides information to help you
configure the XM-360 over a DeviceNet network.
Appendix C “DeviceNet Objects” provides information on the DeviceNet
objects supported by the XM-360 module.
For definitions of terms used in this Guide, see the Glossary at the end of the
Guide.
Document Conventions
There are several document conventions used in this manual, including the
following:
The XM-360 Process module is referred to as XM-360, Process module,
device, or module throughout this manual.
TIP
A tip indicates additional information which may be
helpful.
EXAMPLE
This convention presents an example.