Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over an EtherNet/IP Network Quick Start - Manual (Page 6)

6 Rockwell Automation Publication IASIMP-QS027A-EN-P - February 2012
Preface
For more information on how to complete the prerequisite tasks with specific Logix5000
controllers, see the Integrated Architecture

: Logix5000 Control Systems Quick Starts Quick
Reference, publication IASIMP-QR024 .
Table 1 - Required Tasks To Complete Before Using this Quick Start
Task Description
Prepare the Logix5000
control system
hardware Assembling the control system and connecting to necessary communication networks. Some components, for
example, a desired Logix5000 controller, system power supply or switch for applications operating on an
EtherNet/IP network, are required. Other components, for example, a network communication module, are
optional.
IMPORTANT: These graphics show the assembly of an example Logix5000 controller.
This task does not include installation of specific hardware components, for example, POINT I/O modules, used
over the networks included in your application.
Prepare the computer Installing necessary software, for example, RSLogix 5000 software, on your computer.
2 (Rear) 1 (Front)