Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over an EtherNet/IP Network Quick Start - Manual (Page 17)

Rockwell Automation Publication IASIMP-QS027A-EN-P - February 2012 17
Prepare the Distributed POINT I/O Module Hardware Chapter 1
Mount the 1734-OB4E Digital Output Module
1. Install the removable terminal base (RTB) on the mounting base.
Make sure the handle is in the down position.
2. Using a small screwdriver, rotate
the keyswitch on the mounting
base to match the position on the
keyswitch on the I/O module.
This example shows the keyswitch
in position 1.
3. Press the 1734-OB4E module into
the wiring base.
4. Snap the handle up to lock the
RTB on the module.
5. Connect the wiring base assembly,
including mounting base, module,
and RTB, to the POINT I/O
Ethernet adapter via the slots on
the right side of the adapter.
6. Slide the wiring base assembly
along the right side of the network
adapter and press it onto the
DIN rail.
Mounting Base
Handle
Removable Terminal Block
Tongue-and-groove Slots
Module