Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over an EtherNet/IP Network Quick Start - Manual (Page 11)

Rockwell Automation Publication IASIMP-QS027A-EN-P - February 2012 11
Preface
Parts List
To complete the tasks described in this publication, you need the parts listed in this table.
For a list of parts required to complete the prerequisite tasks listed in Table 1 - Required Tasks To
Complete Before Using this Quick Start on page 6 , see the documentation describing
those tasks.
Additional Resources
Use the additional resources listed in this table for more information when using POINT I/O
modules over an EtherNet/IP network in a Logix5000 controller project.

Quantity Cat. No. Description
1 1734-AENT POINT I/O Ethernet adapter
1 1734-OB4E POINT I/O protected output module
1 1734-TB or 1734-TBS Wiring base with removable IEC screw terminals (1734-TB)
Wiring base with removable IEC spring terminals (1734-TBS)
1 1794-PS3
FLEX

I/O 85…264V AC to 24V DC 3 A power supply
1 1585J-M8PBJM-2 RJ45-to-RJ45 patchcord Ethernet cables
Table 2 - Additional Resources
Resource Description
POINT I/O Ethernet Adapter Installation Instructions,
publication
1734-IN590
Describes how to install the 1734-AENT POINT I/O Ethernet adapter and
contains technical specifications.
POINT I/O and ArmorPOINT

I/O 2 Port EtherNet/IP
Adapters User Manual, publication 1734-UM014
Describes how to install, configure, and troubleshoot your 1734-AENT
POINT I/O EtherNet/IP adapter.
POINT I/O Protected Output Module,
publication
1734-IN056
Describes how to install the 1734-OB4E module.
POINT I/O Wiring Base Assembly Installation Instructions,
publication
1734-IN013
Describes how to install the POINT I/O wiring base.