Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over an EtherNet/IP Network Quick Start - Manual (Page 18)

18 Rockwell Automation Publication IASIMP-QS027A-EN-P - February 2012
Chapter 1 Prepare the Distributed POINT I/O Module Hardware
Mount and Wire the 1794-PS3 Power Supply
Use a 1794 FLEX I/O power supply to power the distributed POINT I/O modules. This
publication uses the 1794-PS3 power supply.
1794-PS3 Power Supply
1. Hook the upper-lip of the DIN rail latch
onto the DIN rail.
2. Press the module onto the DIN rail next
to the POINT I/O Ethernet adapter.
3. Connect the 120/240V AC power L1,
L2/N and Ground wires to your AC
power source.
WARNING: Verify that all incoming power is turned off before wiring power.
r e w o P
C D V 4 2
Y L P P U S R E W O P
3 S P - 4 9 7 1
V 4 2
M O C
GR
L2/N
L1