Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over an EtherNet/IP Network Quick Start - Manual (Page 10)

10 Rockwell Automation Publication IASIMP-QS027A-EN-P - February 2012
Preface
How Hardware is Connected
This quick start demonstrates the following possible control system.
Required Software
To complete examples in this quick start, you need the software described in this table.
Software Version Required for This Task
RSLogix 5000
20.00.00 or later
(1)
(1) RSLogix 5000 software, version 20.00.00 or later is required for use of this quick start because the example Logix5000 controller, and associated tasks, described herein are
completed in a CompactLogix 5370 L3 control system. CompactLogix 5370 control systems require RSLogix 5000 software, version 20.00.00 or later. If you connect a 1734
POINT I/O module over an EtherNet/IP network in a Logix5000 control system that uses a different controller, the minimum version may differ.
Create or change RSLogix 5000 projects to
use POINT I/O modules.
BOOTP/DHCP utility Version automatically installed with
RSLogix 5000 software and varies according
to that software’s version. Set or change the IP address for 1734-AENT
POINT I/O Ethernet adapter.
1 2 3 4
5 6
7 8
0 2 0 1734-AENTR Module
Status Network
Activity Network
Status Point Bus
Status System
Power Field
Power
POINT I O
Link 1
Activity/
Status
Link 2
Activity/
Status
IP ADDRESS
Computer
POINT I/O Modules
Logix5000 Controller
with Ethernet
Connection
Stratix 6000
Managed Switch