Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over an EtherNet/IP Network Quick Start - Manual (Page 28)

28 Rockwell Automation Publication IASIMP-QS027A-EN-P - February 2012
Chapter 2 Add the POINT I/O Ethernet Adapter and Digital Output Module to an RSLogix 5000 Project
12. Right-click the OB4E_Light tag
and choose New “OB4E_Light”.
OB4E_Light is an alias tag for the
I/O point tag name. With an alias
tag, you can assign a simple name
to a physical I/O point address.
13. From the Type pull-down menu,
choose Alias.
14. From the Alias For pull-down
menu, browse to the 1734-OB4E
digital output module and choose
any bit.
This example uses
my_aent:1:O.Data[0].
15. Click Create and Close.
This graphic shows the rung created
with these steps.