Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 48)

5-8 Setting Up DH+ Direct Communications
Using RS-232 to
DH+
Communications RS-232 to DH+ direct communications use an external converter (1770-KF2).
Important: If you are using an internal interface card, refer to “Using DH+
Direct Communications” on page 5-2.
Hardware
Required Hardware
The hardware required for this type of communications depends on the drive
type. Refer to the following table:
Setting Up the Hardware
To use DriveTools32 with this type of communications, you must:
• Ensure that the drive and adapter are properly installed and powered.
• Ensure that cables are securely connected and protected from damage.
Configuring RSLinx
For RS-232 to DH+ communications, you must configure RSLinx for RS-232
serial communications. Refer to the “Configuring RSLinx” section in Chapter 3,
Setting Up RS-232 Point-to-Point Serial Communications, for instructions on
configuring RSLinx.
Drive Required Drive Hardware Required Computer Hardware
1336
FORCE PLC Communications Adapter Board
(1336-GT1EN) RS-232 port and 1770-KF2
1395 Multi-Communications Adapter Board
(1395-KP51) RS-232 port and 1770-KF2
A-B/
Stromberg 3500-TBX card
(147096 or 157676) RS-232 port and 1770-KF2