Rockwell Automation 1746-NT4 Series B,D17466.6.1 SLC 500 4-Channel Thermocouple/mV Input Module User Manual - Manual (Page 21)

1 Publication 1746-UM007C-EN-P - July 2004
Chapter
2
Quick Start for Experienced Users
This chapter can help you to get started using the NT4 4-channel
thermocouple/mV module. The procedures are based on the
assumption that you have an understanding of SLC 500 products. You
should understand electronic process control and be able to interpret
the ladder logic instructions required to generate the electronic signals
that control your application.
Because it is a start-up guide for experienced users, this chapter does
not contain detailed explanations about the procedures listed. It does,
however, reference other chapters in this book where you can get
more information about applying the procedures described in each
step. It also references other documentation that may be helpful if you
are unfamiliar with programming techniques or system installation
requirements.
If you have any questions or are unfamiliar with the terms used or
concepts presented in the procedural steps, always read the
referenced chapters and other recommended documentation before
trying to apply the information.
This chapter includes:
•
Required Tools and Equipment
•
Installation Procedures
Required Tools and
Equipment Have the following tools and equipment ready:
•
medium blade screwdriver
•
medium cross-head screwdriver
•
thermocouple or millivolt sensor
•
appropriate thermocouple extension wire (if needed)
•
4-channel thermocouple/mV input module (1746-NT4)
•
programming equipment