Rockwell Automation Logix5000 Controllers I/O and Tag Data Programming Manual - Manual (Page 11)

Chapter 1
Communicate with I/O modules
To communicate with an I/O module in your system, you add the module to the
I/O Configuration folder in the Controller Organizer.
When you add the module, you also define a specific configuration for the module.
While the configuration options vary from module to module, these are some
common options that you typically configure:
• Requested packet interval on page 12
• Communication format on page 12
• Electronic Keying on page 15
Introduction
Rock well Automati on Publication 1756- PM004E -EN-P - October 2014 11