Supported mibs – Rockwell Automation 1783-EMS08T Stratix 6000 Ethernet Managed Switch User Manual User Manual
Page 22

22
Rockwell Automation Publication 1783-UM001D-EN-P - January 2013
Chapter 2
Network Services Setup
Supported MIBs
The Stratix 6000 switch supports the MIBs listed below.
• MIB-II—The published definition of MIB-II has been modified for the
Stratix 6000 switch, as described in
MIB-II Modifications
below. For a
detailed definition of MIB-II, refer to RFC 1213 at
.
• ETHERLIKE-MIB—For a detailed definition, refer to RFC 1643 at
.
• RMON-MIB—The Stratix 6000 supports only the Ethernet Statistics
Group in the RMON-MIB. For a detailed definition, refer to RFC 2819 at
.
MIB-II Modifications
Standard read-write access has been changed to read-only access for the MIB-II
variables listed below.
interface.if Table.ifEntry.ifAdminStatus
(Fixed value—device is UP)
at.atTable.atEntry.atIfIndex
at.atTable.atEntry.atPhysAddress
at.atTable.atEntry.atNetAddress
(The ARP cache table cannot be modified)
ip.ipForwarding
(Fixed value, not-forwarding,
not acting as a gateway)
ip.ipDefaultTTL
(Fixed value IP_DTTL - 60s)
ip.ipRouteTable.ipRouteEntry.ipRouteDest
ip.ipRouteTable.ipRouteEntry.ipRouteIfIndex
ip.ipRouteTable.ipRouteEntry.ipRouteMetric1
ip.ipRouteTable.ipRouteEntry.ipRouteMetric2
ip.ipRouteTable.ipRouteEntry.ipRouteMetric3
ip.ipRouteTable.ipRouteEntry.ipRouteMetric4
ip.ipRouteTable.ipRouteEntry.ipRouteNextHop
ip.ipRouteTable.ipRouteEntry.ipRouteType
ip.ipRouteTable.ipRouteEntry.ipRouteAge
ip.ipRouteTable.ipRouteEntry.ipRouteMask
ip.ipRouteTable.ipRouteEntry.ipRouteMetric5
(A routing entry cannot be added via SNMP)