Rockwell Automation 1403-NENET Ethernet Communication Card Installation Instructions - Manual (Page 8)

Publication 1403-IN005A-EN-P
4 Product Description
Figure 4 Installing Closure Plate
8. Apply Master Module control power.
Field Service
Considerations If the Ethernet Communications Card requires service, please contact your
nearest Rockwell Automation Sales Office. To minimize your inconvenience,
the initial installation should be performed in a manner which makes removal
easy.
General Operation Communications Card Set-Up
All Ethernet card configuration items (Table 4 on page 6) can be changed via
the Display Module or via the RS-232 setup port on the Ethernet card. If using
a Display Module for Ethernet card configuration, all of the communication
configuration items can be found in the Display Module menu/parameter
structure under: Program
➞ Configuration ➞ Communication. (Refer to
1403 Powermonitor II Instruction Sheet, Publication 1403-IN001A-US-P for
general information on Display Module operation.)
The serial port on the 1403-NENET may be used to set communications
options as well. Follow these steps:
1. Connect to a PC using a standard RS-232 null modem cable.
2. Run a communication application (such as Hyper Terminal) on the PC.
3. Set the communications parameters. Se eTable 2 for communications
parameter settings.
IMPORTANT
Make sure cables do not twist.
NOTE
Refer to Appendix D on page D-1, for screw torque
requirements and wire sizes.