Rockwell Automation 1403-NENET Ethernet Communication Card Installation Instructions - Manual (Page 18)

Publication 1403-IN005A-EN-P
B-4 Ethernet Communication Card Data Tables
1.30 Oscillograph Buffer
Type
(5)
0 = Hold
1 = Overwrite 1 34 0 to 1
1.31 Number of Pretrigger
Cycles for the 12 Cycle
Oscillogram
(5)
-1 = No Pretrig
0 to +8 = Cycles 0 35 -1 to +8
1.32 IEEE 519 Max. Short
Circuit Current
(5)
0.0 to 10,000,000.0 0 36 0 to 9999
37 0 to 4
1.33 IEEE 519 Max.
Demand/Load
Current
(5)
0.0 to 10,000,000.0 0 38 0 to 9999
39 0 to 4
1.34 Save Status Changes
to Event Log 0 = No
1 = Yes 0 40 0 to 1
1.35 Vaux Voltage Mode 0 = AC
1 = DC 0 41 0 to 1
1.36 Filter Mode(1403-MM)
Enable THD (1403-LM) 1 to 3 (1403-MM)
0 to 1 (1403-LM) 2 (1403-MM)
0 (1403-LM) 42 1 to 3 (1403-MM)
0 to 1 (1403-LM)
1.37 Enable Min_Max Log 0 = No
1 = Yes 1 43 0 to 1
Reserved 44
(1) Available on 1403-MM firmware V2.0 or later and 1403-LM firmware V1.01 or later.
(2) This value is 1 for 1-Amp Master Module (Cat. No. 1403-MM01X) or 5 for a 5-Amp Master Module (Cat. No. 1403-MM05X).
(3) Available on firmware V3.00 or later (reserved in previous versions).
(4) For transitional KYZ pulse enter 0.
(5) 1403-MM only, not available on 1403-LM version.
Table B.2 Device Configuration Data Table - Write and Read (File N11)
Parameter No. Parameter Name Master Module Range Default
Setting Element Range