Rockwell Automation 825 Smart Motor Manager User Manual - Manual (Page 38)

3-5 Functions
Publication 825-UM001B-EN-P January 2001
Setting the Operation Parameters (Set Values)
Text and data are indicated alternately (approximately 2 s text and 1 s data). On the “second
line,” the data that is factory set or subsequently modified is displayed. Functions not
activated (OFF) are not indicated.
1. To set the operation parameters, repeatedly press the Values button until “SET
VALUES” appears on the display.
Figure 3.1 Setting Mode
2. Press Select (Up or Down) until the desired parameter (e.g., “FULL LOAD CURR”
and “35 Amp”) appears (display alternates between text and data).
Figure 3.2 Menu Selection
3. Press the Settings (Change) button once. The set value begins to flash. A new set value
can now be entered by means of the Select keys (Up or Down). The entry is completed
by pressing Settings (Enter).
Values
Recorded
Actual
Set
Select Settings
Enter
Change
SET VALUES
Values
Recorded
Actual
Set
Select Settings
Enter
Change
FULL LOAD CURR
35 AMP