Rockwell Automation 193-DNCT DeviceNet Configuration Terminal User Manual - Manual (Page 74)

70 Rockwell Automation Publication 193-UM009B-EN-P - February 2013
Chapter 17 Terminal Setup Menu
and start proxying. It also allows all devices to come online before
AutoAddressing.
Password Menu The 193-DNCT has five passwords: one primary (master) password and four
secondary passwords. When the primary password has been configured and
correctly entered the operator will gain full access to all features in 193-DNCT.
The secondary passwords can be configured to limit the features that are
associated with that password, so when a secondary password is entered, the
operator will only gain access to limited features in the 193-DNCT. The
following choices may appear when the Password selection is chosen from the
HIM Setup Menu:
This is the Baud Rate that is used if
AutoBaud is disabled
PowerUp
Delay (in
seconds)
Node Number of the 193-DNCT if
AutoAddress is disabled. If
AutoAddress is enabled, this is the
starting Node Number
Must have the
primary
password set for
this selection to
appear
Must have at
least one
password
logged in for this
selection to
appear