Yamato Scientific DNF 910 Constant Temperature Ovens - Manual (Page 45)

41
Operation Method
Program Creation Method
3 Program creation;
Step 8 (S08) to Step 9 (S09)
TROUBLE
ENTER CANCEL
DOOR Set TEMP 0℃
S09(un-used)
Set TEMP ► 0℃
S09(un-used)
Fan ► ON
S09
Program End
S09
①
Keep pressing the PROGRAM key until "SteP 8" (S08) is
displayed.
② Edit in the same way for Step 8 (S08).
③ Keep pressing the PROGRAM key until "SteP 9" (S09) is
displayed.
④ Press the ENTER key. The setting temperature
selection screen is displayed.
⑤
Press the ENTER key. The setting temperature edition
screen is displayed. Set "End" using the "▼▲" and
press the ENTER key to decide it.
⑥
Press the PROGRAM key. The fan rotation speed
selection screen is displayed.
⑦ Press the ENTER key. The fan rotation speed edition
screen is displayed.
⑧ Keep pressing the PROGRAM key until "Program End"
is displayed. Press the ENTER key to terminate the
program setting.
⑨ The setting of program is completed by pressing the
ENTER key. The unit enters into the standby state.