Yamato Scientific DNF 910 Constant Temperature Ovens - Manual (Page 38)

34
Operation Method
Input Program; Delete Step
1 Step deletion procedure
①
Press the program key. The program menu starts and step number selection screen is displayed.
Press the "▼▲". The registered step numbers and the smallest number of un-used step are
displayed in sequence. Select the step number to be deleted.
PROGRAM
→
TROUBLE
ENTER CANCEL
DOOR Select step S01
Program OPR
② Press the ENTER key.
ENTER
③ Press the PROGRAM key and select "Delete step".
PROGRAM
④ Press the ENTER key. The selected step is deleted and the "Program End" screen is displayed.
TROUBLE
ENTER CANCEL
DOOR Delete step
S01
→
Program End
S01
⑤
Press the ENTER key to end the program edition if the step to be deleted is correct.
ENTER
⑥ The unit enters into standby state where step deletion is completed.
Standby
2002/01/01 12:00