Yamato Scientific DNF 910 Constant Temperature Ovens - Manual (Page 34)

30
Operation Method
Input Program; Set the Repeat Initiating Step
1 Repeat initiating step setting procedure
①
Select the "Rep. start" and press the ENTER key. The setting edition screen is displayed. The
blinking "" (cursor) goes out and the setting value blinks instead.
Rep. start ► No
S01
Rep. start No
S01
ENTER
(Selection screen)
→
(Edition screen)
②
Select the step number from which the repeat starts using the"▼▲", then press the ENTER key.
TROUBLE
ENTER CANCEL
DOOR Rep. start S01
S07
→
TROUBLE
ENTER CANCEL
DOOR Rep. start S01
S07
(Decide the input) (Selection screen)
③
Press the CANCEL key to cancel the input. The value is cancelled and the screen returns to the
setting item selection screen.
TROUBLE
ENTER CANCEL
DOOR Rep. start S03
S07
→
TROUBLE
ENTER CANCEL
DOOR Rep. start No
S07
(Cancel the input) (Selection screen)
④
Press the PROGRAM key to display the next selection screen after the setting of repeat initiating
step is completed.