Yamato Scientific DNF 910 Constant Temperature Ovens - Manual (Page 39)

35
Operation Method
Input Program; End Program
1 End program procedure
①
Select the "Program End" and press the ENTER key. The program edition is completed.
TROUBLE
ENTER CANCEL
DOOR Program End
S01
→
Standby
2002/01/01 12:00
②
The program edition has not done if the POWER or CANCEL key is pressed before pressing the
"Program End" at the end of program edition.
③ Make sure to press the "Program End" after program edition.
The "Program End" can be set at any steps in addition to at the edition step.