Weidmuller WI-I/O-9-U2: Wireless Mesh I/O & Gateway User Manual V1.2.2 - Manual (Page 56)

55
IP Address List
When all radios have been entered into the project, selecting IP Address List from the
project tree will display the Radio name along with its Radio and Ethernet IP address,
Subnet and Network address.
The configuration screen for this option is a read only screen. All parameters for this
can only be edited from the radio selection itself.
4.3.5 Mappings
Mappings are used to send I/O values between WI-I/O 9-U2 modules. The I/O is
typically sent via the Radio interface however at times it can be used to be sent via the
Ethernet interface between modules. To create a new mapping select Add from the
Configuration display once Mappings has been selected.
Mappings are configured by selecting the “Units”, “Mappings” then “Add”.
Figure 38 - Mappings
Mappings are sent to the destination by two different methods, Change of State (COS)
and Updates.
The first method, ‘Change of State’ monitors the state of the input that is being mapped
and when the state changes it triggers a transmission. This is the primary way of
sending input values to a destination. As soon as the input change occurs the value is
immediately sent to the destination
Digital mapping are
triggered when the input changes from ‘On’ to ‘Off’ or ‘Off’ to ‘On’.
Figure 37 - ID Address List