Weidmuller usa corporate headquarters – Weidmuller WI-I/O-9-U2: Wireless Mesh I/O & Gateway User Manual V1.2.2 User Manual

Page 2

Weidmuller USA Corporate Headquarters

821 Southlake Boulevard
Richmond, Virginia 23236

804.794.2877 Main
800.849.9343 Customer & Technical Support
804.794.0252 Fax
[email protected]

Thank you for your selection of the WI-I/O 9-U2 I/O Module. We trust it will give you many
years of valuable service.

ATTENTION!

Incorrect termination of supply wires may cause internal damage and will void warranty. To
ensure your WI-I/O 9-U2 module enjoys a long life, double check ALL your connections
with the user manual before turning the power on.

CAUTION:

To comply with FCC RF Exposure requirements in section 1.1310 of the FCC Rules,
antennas used with this device must be installed to provide a separation distance of at
least 20 cm from all persons to satisfy RF exposure compliance.

Avoid:



Operating the transmitter when someone is within 20 cm of the antenna



Operating the transmitter unless all RF connectors are secure and any open

connectors are properly terminated



Operating the equipment near electrical blasting caps or in an explosive atmosphere

All equipment must be properly grounded for safe operations.

All equipment should be serviced only by a qualified technician

SAFETY Notice:

Exposure to RF energy is an important safety consideration. The FCC has adopted a
safety standard for human exposure to radio frequency electromagnetic energy emitted by
FCC regulated equipment as a result of its actions in Docket 93-62 and OET Bulletin 65
Edition 97-01.