Commissioning functions, Section 4 – Titus Sensor STE-8001 and STE-8201 User Manual
Page 13
Revision A
13
SECTION 4
Commissioning functions
This topics in this section are advanced topics for control technicians
and engineers.
The commissioning functions that are accessible through an STE-8000 series
sensor are values and settings that are entered during the installation and
commissioning of a VAV terminal unit. Typically these functions do not change
after the installation and commissioning process.
To set up the commissioning functions, you will need the following:
◆
Information about the VAV terminal unit including the configuration for
fans and reheat
◆
The installation and operation manual supplied with the controller to
which the STE-8000 series sensor is connected.
◆
The building automation system plans.
Users may change the occupied heating and cooling setpoints without accessing
the commissioning functions. This procedure is covered in
.
Note
The instructions for commissioning functions cover all of the functions that an
STE-8000 sensor can set up in the BAC-8000 series of controllers. Not all
functions are available on every model of controller. Consult the installation
and operation manual supplied with the controller to verify the functions and
options that are available.