Titus HEPAlert IOM for TLF Diffusers - Manual

Installation Manual
IOM-HEPA-TLF-00
725343-01
09-30-04
HEPA
LERT
™ LED L
IGHT
Kit
Installation, Operation, and Maintenance Manual
for the TLF Diffuser
Contents Page
Introduction.............................................................1
General ....................................................................1
Safety .......................................................................1
Inspection................................................................1
Product Description ...............................................1
Tools and Equipment .............................................1
Preparation..............................................................1
Installation...............................................................2
Startup and Operation............................................5
Calibration...............................................................5
Maintenance............................................................5
Abbreviations..........................................................6
Appendix - Bill of Materials ...................................7
Introduction
This document provides installation, operation, and
maintenance information for the Titus HEPA LERT ™ LED
Light Kit installed on TLF diffusers, specifically.
Additional information may be found at the Titus website,
www.titus-hvac.com.
General
The following information is to be used by the installer as a
guide. Since each installation is unique unto itself, only
general topics are covered. Topic order may not be the
same as required by actual installation.
This guide is not intended to supersede or circumvent any
applicable national, state, or local codes.
The installation is to be performed only by individuals
whose experience meets or exceeds the requirements of
the work involved.
The installer MUST read the entire contents of this guide
and develop a thorough understanding before beginning
installation.
Due to a continuing program of product research, Titus
reserves the right to discontinue or change without notice,
any or all specifications or designs without incurring
obligations.
Safety
The installation and / or servicing of comfort conditioning
equipment can be hazardous due to system pressures
and electrical devices.
Caution: Only trained and qualified personnel
should perform service and/or installation.
Observe all precautions and warnings in product
data or attached to the unit.
Follow all safety codes. Wear eye protection and gloves.
Have a fire extinguisher readily available.
Caution: Disconnect all power supplies before
accessing equipment.
Disconnecting more than one power supply may
be required to de-energize some equipment.
DANGER
ELECTRIC SHOCK CAN CAUSE DEATH.
Inspection
Thoroughly inspect all packages upon receipt. Ensure
carton(s) have not been dropped, crushed or punctured.
Inspect all contents for damage. If damage is found,
immediately file a claim with the delivering carrier.
Product Description
The HEPA LERT LED Light Kit provides an easy and visible
verification for HEPA filter cleanliness from the occupied
space. The kit uses pressure sensors and light emitting
diodes (LED) indicators to alert clean room users when
filter replacement is needed.
Tools and Equipment
In addition to the HEPA LERT LED light kit the following
items (supplied by others) assist the installation process.
•
Transformer (Class 2 – 120 Vac to 24 Vac
transformer, rated for 40 VA)
• Power cord for transformer
• Silicon sealant
• Rubber tubing – 3/8-inch OD
• Screw drivers (various sizes of Phillips and flat
blades)
• Drill and drill bits (sizes needed are 3/16-, ¼-, 3/8-,
and 5/8-inch)
Preparation
• Unpack HEPAlert LED Light Kit and check contents
against Bill of Materials.
• Sort contents, especially wire, screws, nuts according
to color, size, and type as listed on the Bill of
Materials.
• Keep Bill of Materials readily available for reference.
• Remove HEPA filter and back pan before attempting
installation.
605 Shiloh Road • Plano, Texas 75074 • 972-212-4800
All rights reserved. No part of this work may be reproduced or transmitted in any form or any means, electronic or mechanical, including photocopying and recording, or by any information storage retrieval system without permission in writing from Air Distribution Technologies.