Titus Sensor STE-8001 and STE-8201 - Manual (Page 12)

KMC Controls
Revision A
User functions
Changing setpoints
12
Changing
setpoints
To enter or change the occupied setpoints you will need a Level 1 password.
Enter occupied setpoints
Procedure Steps STE display
Starting display Start from the temperature display.
Enter the level one
password 1. Press the button.
2. Press the or buttons to change
the first digit.
3. Press the button to select the next
digit. Repeat for all four digits.
4.
Note: If a Level 1 password has not
previously been entered, the display
will change to the occupied cooling
setpoint display after Step 1.
Set the occupied
cooling setpoint 1. Press the or buttons to change
the cooling setpoint temperature. The
setpoint changes in increments of 0.5
degrees.
2. Press the button to save the value.
The display advances to set the
heating setpoint.
Set the occupied
heating setpoint 1. Press the or buttons to change
the heating setpoint temperature.
The setpoint changes in increments
of 0.5 degrees.
2. Press the button to save the value.
The display returns to the
temperature display.
72
12S1
Set Point
Set
Point
PSW1
OOOO
Set
Point
7SO
COOLING
Set
Point
68O
HEATING