STEMCO Aeris - Manual (Page 8)

Aeris Installation and Service Manual
Page 8 of 42
Recommended Tool List

1/2” Drill

Drill Speed Recommendations
- Drill Speed 7/16” drill…262 rpm to 786 rpm
- Drill Speed 5/16” drill…367 rpm to 1100 rpm

Drill Bushings (Type SF) 5/16”, 7/16” and 9/16”

Drill Bits 5/16”and 7/16”

A variable speed ½” drive electric drill is recommended

1/4-18 NPT Tap

L1 NPT Plug Gauge

Medium to Heavy Duty Extension Cord

Wire Strippers

Wire Crimper

Combination Wrenches – 1/2", 9/16” and 11/16”

Hammer

Drill Fixture (See page 12)

Ratchet and Sockets - 1/2", 9/16” and 11/16”

#2 Phillips Screwdriver Bit for Drill

Cutting and Tapping Fluid

10” Adjustable Wrench (Crescent)
Aeris Installation
Trailer Preparation
! WARNING: Before starting any work on trailer, park trailer on a level surface. Chock all wheels in front
and back of each wheel to prevent the trailer from moving. Support the trailer with safety jack stands.
Do not work under vehicle supported by jack stands only! Jacks can slip and fall over. Serious personal
injury or damage to components can result. See Figure 1
! WARNING: To prevent serious eye injury, always wear approved safety glasses when performing trailer
maintenance and service.