STEMCO Qwik Kit Mack and Volvo King Pin - Manual

NO REAM INSTALLATION
Instructions for the Mack & Volvo FXL Axle/K536M STEMCO Kaiser Qwik Kit
• Set axle down on jack
stands placing them under
spring perches.
• Disconnect steering arms
and remove grease fittings
from top knuckle caps.
• Remove top and bottom
caps.
• Remove nut from kingpin
using an inch drive socket
and breaker bar.
• Install kingpin removal tool
ST90-1 on top of king pin.
(FIG. 1)
• Strike the removal tool with a
large hammer to break king-
pin loose from axle eye.
(FIG. 2)
• Remove the removal tool
from kingpin.
• Using a suitable brass drift
punch and hammer drive
kingpin down through axle
and spindle.
• Remove knuckle from axle.
• Remove lower seal from
knuckle and discard. Clean
knuckle thoroughly, so it is
free of grease and dirt.
• Remove old nylon bushing
from knuckle using a brass
drift punch. Remove top
bearing cup using a suitable
steel drift punch.
• Measure the thickness of
the bearing cup seat with a
micrometer. (Measure in
four places) Thickness
should be between .392 and
.394. If thickness is not with-
in these specifations add the
appropriate amount of
shims to achieve this speci-
fation or replace the spindle
• Inspect axle and knuckle for
wear that might have been
caused by faulty wheel bear-
ings or kingpin components
and replace if necessary.
• Install spiral bushing into
lower knuckle bore.
• Coat the under ledge sur-
face, in the area of the
knuckle upper bearing, with
grease. This allows the
knuckle to slide onto the
axle during later assembly.
Clean all grease and dirt
from axle eye thoroughly.
• Position a new lower seal on
the knuckle (the white nylon
insert inside the seal faces
down against the knuckle).
Do not coat lower seal with
grease.
• Slide the knuckle onto the
axle eye while pressing the
lower seal down at the same
Q W I K
K I T TM
PAGE 1 01 577 1005 NOV-2013
GETTING HELP
USE THE STEMCO Kaiser TECHNICAL SERVICE LINE
888-854-6474
WARNING: STRIKING STEEL PARTS WITH HAMMERS CAN RESULT IN CHIP PROJECTILES, ALWAYS WEAR SAFETY GLASSES TO PROTECT YOURSELF AGAINST
INJURY. STEMCO Kaiser IS NOT RESPONSIBLE FOR ANY INJURY THAT MAY OCCUR DURING THIS PROCESS.
4641 Industrial Drive, Millington, MI 48746 • 888-854-6474 • Fax: 989-871-4640 www.stemcokaiser.com
CONTINUED
The following assembly instructions are recommended for completing the MACK &
VOLVO FXL front steering axle king pin repair. This is a very unusual and unique
designed axle in comparison to the majority of common axle assemblies. Reading and
following these instructions is critical to successfully performing the king pin procedure!