STEMCO Aeris - Manual (Page 37)

Aeris Installation and Service Manual
Page 37 of 42
• Next tuck all the wires inside the 7 pin terminal box and install the cover back on the box. Make sure you
don’t trap any wires between the cover and the box that could cause the wire to short.
• Use tie wraps to attach 3 wire cable and wire cable from the light indicator to the airlines leading out of
the 7 pin connector box. See Figure 34
IMPORTANT: Make sure you leave enough slack in the wires in the connector box to be able to remove the
cover and work on the wiring without pulling any of the wiring lose from connectors when removing the
cover of the box.
Figure 34
Decal Location
• Place decals on front of trailer by the indicator light and on the inside and outside of the control box cover.
See Figure 34