Aeris installation and service manual – STEMCO Aeris User Manual
Page 22
Aeris Installation and Service Manual
Page 22 of 42
Figure 16
• Repeat same procedures on remaining ends of all spindles. Make sure when feeding airline tubing into
axle it heads towards the correct spindle end.
IMPORTANT: Make sure to leave some slack in end of line when cutting for the hubcap airline fitting. If
hubcap needs to be removed you will need enough slack to unbolt the hubcap and be able to remove the
airline from the air fitting.
Figure 17
See also other documents in the category STEMCO For the car:
- Voyager and Discover (1 page)
- Guardian and Guardian HP(TQM) (1 page)
- Standard and Grit Guard HP(TQM) (1 page)
- Pinion Seal (1 page)
- Pro-Torq (2 pages)
- 610-0024 Hubodometer Bracke (1 page)
- 610-0011 Hubodometer (1 page)
- Dual Tire AirBAT RF (2 pages)
- AirBAT RF Single Tire (2 pages)
- AirBAT SST RF (2 pages)
- AirBAT DAS (1 page)
- HandBAT RF (17 pages)
- Tractor Interface Module (20 pages)
- 821-7000 BatRF Tractor Interface Module (9 pages)
- 821-7002 BatRF Tractor Interface Module - Switch Input (TIM-SI) (7 pages)
- Serial Number Recording Form For BatRF/SkyBitz (1 page)
- DataTrac PRO (2 pages)
- DataTrac Vibration Isolation Bracket (1 page)
- TracBAT Pro (2 pages)
- Aeris Pre-Prep Axle (2 pages)
- Aeris SmartSense Upgrade Kit (3 pages)
- Aeris Inflation System Troubleshooting (18 pages)
- Moisture Ejector (2 pages)
- Moisture Ejector (1 page)
- Qwik Kit King Pin Repairs (1 page)
- Plus Kit King Pin Repairs (1 page)
- Qwik Kit King Pin Spindle Conversion Ford and Mack (1 page)
- Top Kick Kodiak (1 page)
- Mack Volvo fxl (2 pages)
- Kit 50034 (2 pages)
- Spring Pin (1 page)
- Qwik Kit King Pin (2 pages)
- Axle Pro (24 pages)
- 84.056.07 Axle Pro (2 pages)
- 84.103.19 Axle Pro (2 pages)
- Qwik Kit Mack and Volvo King Pin (2 pages)
- Qwik Kit Bushing (1 page)