STEMCO Kit 50034 - Manual

The following guide is for tool kit
50034. This tool allows for the
removal and installation of the
bushing in kit 50032.
Included in kit:
• Hex Nut
Tightens components on bolt.
• Bolt
Pushes bushing into control arm bore.
• Bushing Driver
Pushes bushing into and out of control arm bore.
• Removal Cup
Holds bushing while it is being removed
from control arm bore.
• Installation Guide
Chamfer guides bushing into control arm bore
eliminating chances of installation failure.
• Installation Washer
Ensures bushing depth alignment.
Removal Tool Setup
(Old Bushing Still Installed
into Control Arm)
1. Install bushing driver onto bolt.
2. Place bolt through the used bushing
3. Install the removal cup so that the cup is facing
the bushing on to the bolt.
4. Add the nut and tighten until bushing has been
completely removed from the control arm.
The rest of the bolt and bushing driver should
slide through the control arm.
5. Check the control arm bore to make sure that
the previous bushing were completely
removed, make sure that the bore is clean
before moving on to the installation phase.
Tool Kit 50034
Removal and Installation Guide for kit 50032
01 577 9020 JAN 2012
GETTING HELP
USE THE STEMCO Kaiser TECHNICAL SERVICE LINE
888-854-6474
WARNING: STRIKING STEEL PARTS WITH HAMMERS CAN RESULT IN CHIP PROJECTILES, ALWAYS WEAR SAFETY GLASSES TO PROTECT YOURSELF AGAINST
INJURY. STEMCO Kaiser IS NOT RESPONSIBLE FOR ANY INJURY THAT MAY OCCUR DURING THIS PROCESS.
4641 Industrial Drive, Millington, MI 48746 • 888-854-6474 • Fax: 989-871-4640 www.stemcogaff.com