SDC EH SERIES ELECTROMAGNETIC DOOR HOLDER 1224, 24120, 24220 - Manual (Page 2)

P:\INSTALLATION INST\ACCESSORIES\INST-EH SERIES.vsd REV B 08-12 Page 2
GENERAL DIMENSIONS
DOOR MAGNET
[27mm]
15/16”
[24mm]
1-1/16” 2-3/4”
[70mm]
4-5/8”
[117.5mm]
3-5/16”
[84.1mm]
SURFACE MOUNT BACK BOX
1-3/4”
[ 44.5mm]
2-1/8”
[54mm]
CATCH PLATE ASSEMBLY
4-5/8”
[117.5mm]
2-3/8”
[60mm]
3-5/16”
[84mm]
1-3/4”
[44.5mm]
2-3/4”
[70mm]
1-1/2”
[38.1mm]
EXTENSION RODS
ASSEMBLY INSTRUCTIONS
CATCH PLATE MOUNTING
STEP 1:
With door magnet securely
fastened, aligned and energized,
proceed with swivel base
assembly.
NOTE: If door extensions are
required, install before step 2.
STEP 2:
Attach swivel portion to magnet,
being careful to center the catch
plate over the magnet.
WRONG RI
GHT
STEP 3:
With catch plate assembly
attached magnetically to door
magnet, peel adhesive backing
off mounting template and slide
over catch plate, making sure
adhesive side faces door.
STEP 4:
Gently close door and with one
hand adjust base of catch plate
to lie flat against the door.
STEP 5:
While keeping slight pressure on
door, slide mounting template
over catch plate to door surface
and apply pressure to template
in a few spots.
WALL
W
AL
L
WA
L
L
DOOR
WA
LL
DOO
R
EHR1 EHR15 EHR2
EHR3 EHRA4
1”
[25.4mm]
1-1/2”
[38.1mm]
2”
[50.8mm]
4”
[101.6mm]
3”
[76.2mm]
PART NUMBER + A = CHROME // PART NUMBER + C = BRASS