SDC 1580 SERIES EMLOCK - Manual (Page 2)

N/C ORG COVER OFF
N/O YEL COVER ON
COM WHT
ATS TD
TIME ADJ.
L-3
-
+
+
GRN
BRN
RED
BAS
AVAILABLE OPTIONS
ATS
BAS
DPS
LED
TD
Anti-Tamper Switch
Magnetic Bond Sensor
Door Position Switch
Tri-Color LED Red or Green
Both on = Yellow
TIME DELAY (1-30 sec) SPDT, DRY,
SPDT, DRY,
SPDT, DRY,
20 mA
40 mA
20 mA
L-3
-
+
+
GRN
BRN
RED
BAS
BAS
DPS
LED
Magnetic Bond Sensor
Door Position Switch
Tri-Color LED Red or Green
Both on = Yellow SPST, No, Dry
SPDT, Dry
20 mA
40 mA
All switches rated @ 250 mA @ 30 VDC
AVAILABLE OPTIONS
ELECTRICAL INSTALLATION IMPORTANT NOTES
1. Use jacketed cable for all wire runs. Refer to the SDC wire
gauge chart for proper lock power wire size (18 AWG
gauge minimum).
2. Use only shielded cable for all signal wires. 22 AWG gauge
(minimum) may be used for signal wires up to 1,000 feet.
3. All wires must be colored coded.
4. Use properly fused power source only. See Electrical
Specifications.
5. Make all Emlock terminal connections according to
Figure 3A or 3B.
INDOOR USE ONLY
Do not run power wires and signal wires in the same cable or
conduit.
Do not install a diode in parallel with any magnetic lock. A diode
will cause a delay when releasing the door and residual
magnetism to occur.
Although SDC recommends the use of a DC power supply, a
transformer with an adjacent mounted full wave bridge rectifier
may be used. A significant voltage drop will occur when using a
full wave bridge rectifier.
Any low voltage condition will cause erratic operation of the
optional bond sensor.
When using a full wave bridge rectifier, all access controls and/or
release contacts must be located between the Emlock and rectifier
to ensure quick release.
P:\INSTALLATION INST\Electromagnetic Locks\INST-1500-10-70-80.vsd REV E 04-06 Page 2
COM GRN
N/O BLU
ELECTRICAL SPECIFICATIONS
Voltage kickback protection standard
SERIES
INPUT VOLTAGE (VDC)
POWER CONSUMPTION (mA)
COIL RESISTANCE (OHMS)
HOLDING FORCE (LBS)
1510
12/24
700/350
1650
35 (PER COIL) *
1570
12/24
250/125
1200
100 (PER COIL) *
1580
12/24
440/220
650
60 (PER COIL) *
*NOTE: For a proper coil resistance reading, turn off the DC voltage. Use an ohmmeter and measure
the resistance between the pins of the plug connector positions E1-E2 and E3-E4
OPTIONAL: 1511-DF DRILL FIXTURE
Drill many doors and frames in a fraction of the time.
1511-DF
1510, 1570 SERIES CONNECTIONS
LOCK PWR -
+
NC OPEN
COM
NO CLOSED
-
-
DPS
NC UNLOCKED
COM
NO LOCKED
-
-
BAS
ELECTROMAGNET
PLUG CONNECTION
FIG. 3A
BAS PLUG IN
EMLOCK
E4
E3
E2
E1
1580 SERIES CONNECTIONS
LOCK PWR -
+
NC OPEN
COM
NO CLOSED
-
-
DPS
NOT USED
ELECTROMAGNET
PLUG CONNECTION
FIG. 3B
EMLOCK
E4
E3
E2
E1
J1