RKI Instruments Pioneer 4W - Manual (Page 125)

CO Transmitter • 22 Pioneer Operator’s Manual
3. Press the UP/YES, DOWN/NO, or ENTER button to continue.
The Select screen appears. The first line (channel 1) is flashing.
NOTE: The example used in this procedure describes calibration for Channels
1, 2, and 3.
4. Press the ENTER button to “select” Channel 1, then press the DOWN/NO button.
The second line (channel 2) is flashing.
5. Repeat step 4 to “select” Channels 2 and 3.
NOTE: The description for Channels 1, 2, and 3 changes to 4-20 Monitor when you
“select” Channels 1, 2, and 3.
6. Press the DOWN/NO or UP/YES button until the Channels Selected screen appears.
7. Verify that you selected the correct channel(s), then press the ENTER button to
continue.
The Choose Calibration screen appears.
NOTE : If one or more of the channels you selected on the Select screen is an oxygen
channel, then the Choose Calibration screen appears as follows.
C H 1 S e l e c t e d
C
C
C H
H
H 2
3
4 S
S
S e
e
e l
l
l e
e
e c
c
c t
t
t e
e
e d
d
d N o
o
o
t
t
t
N
N
N o t
Y o u h a v e S e l e c t e d
t h e s e C h a n n e l s :
1
E N T E R N e x t , E S C P r e v
3 , 2 ,
E N T E R N e x t , E S C P r e v
C h o o s e C a l i b r a t i n o
Z e r o P r o c e e d
S p a n P r o c e e d
E N T E R N e x t , E S C P r e v
C h o o s e C a l i b r a t i n o
Z e r o
S p a n O x y g e n
n e g y x O S p a n
Z e r o
(
(
)
)